|
|
I've cut to length the back and inside toe kick pieces, now they need to be ripped to 4". It can be a bit of a challenge to rip pieces smaller than the width of the guide rail, here is one way to do it. I use a larger piece that is known to be square, it this case the vanity side that I already sized. Place it on the MFT and but the piece to be ripped up to it of support. After I get it all lined up, I set the stop so the whole thing can't move during the cut and to make the next two pieces the same.
|
|
Here it is ripped to 4".
|
|
With the plywood all cut to size, I'll move on to the poplar.
|
|
The rails and stiles are cut the same way.
|
|
This is what I ended up with, the front toe kick, stiles and rails for the doors and the top panel.
|
|
I've laid the arch out on the front toe kick.
|
|
Just finishing the arch cut out.
|
|
|
|
