|
| |
A look at the OF 1010 EQ. Festool's little router that is big on features.
|
|
Here's a peek inside the systainer.
|
|
What's inside: OF1010 router, plug-it cord, PC stlye guide bushing adaptor, chip catcher, guide rail attachment, edge guide, collet wrench, 1/4" collet, 8mm collet, and manual in a systainer # 3. Edge guide no longer included with the set, it is now sold as an accessory.
|
|
|
Some of the specs. 1010 watts/8.5 amp, 1.4 hp; depth adjustment range: 55mm (2-3/16"), Fine depth adjustment range: 8mm (5/16"), three adjustable depth turret stops, electronic controlled motor with soft start, constant speed under load, stepless speed adjustment and thermal overload protection and around six lbs. (2.7kg).
|
|
The 1010 has fine depth adjustment in .1 mm increments, that is approximately 1/256 of an inch!
|
|
The turret has three adjustable stops, use a sloted screwdriver to adjust the stops.
|
|
The removable (with screwdriver)chip catcher does a very good job collecting the dust from edge routing.
|
 |
The chip catcher swivels to stay where it's needed.
|
|
|
Click on the image above to see a video of the 1010 chamfering a 2x4. Notice how well the 1010 collects the chips with the CT22 attached!
|
One of the nice things about the "Ten Ten" is the fact that it comes with the edge gudie and the guide rail attachment. Shown here is the edge guide.
|
 |
|
|
Click on the image above to see a video of the edge guide at work.
|
|
|
|
